Splitter Cable for XplorerHD (V.1)

For those with the XplorerHD V.1, we now offer a splitter cable option so you do not have to remove the VTX cable to extract videos from your VTX.

This Y-Cable will allow you to have the USB-C adapter connected at all times.

This would be very convenient as you can mount the USB-C adapter to your existing setup for easy video extraction.

Here is how to install it.

DISCLAIMER: For those who have the V.2, (USB-C port integrated to the bottom plate) this cable will NOT work.

Removing Old Cable

It is the middle plug. Hold both wires and pull "gently" until it unplugs

Now, hold onto both wires attached to the connector that is attached to the VTX and pull gently until it comes out. (The pins inside the VTX are very fragile!)

Here is a reference for the correct wire harness when removed (2 pin middle)

Installation

The pins are towards the outside. Note, the contact points (silver) are not shown here and this is how it goes in. Carefully line it up and insert.

After inserting, please make sure it is flush. (There should have been very little resistance and it should pop in)

For the VTX side, note the reference. (The pins are exposed) Please, please be careful on this next step as improper installation will bend the pins inside the VTX and the unit will not properly work.

Tip: Visually like up the plug first then slowly push all sides in.

There should be very little resistance, once inserted, please make sure it is flush by gently pushing on each corner.

Lastly, the reference to the USB-C adapter is with the pins exposed as shown.

Installed. You can either choose to mount the entire USB-C adapter or remove it for easy access later.